Toyota Corolla (E170) 2014–2019 Owners Manual / When trouble arises / Steps to take in an emergency / If you have a flat tire / Before jacking up the vehicle
Toyota Corolla (E170): Before jacking up the vehicle
● Stop the vehicle on a hard, flat surface.
● Set the parking brake.
● Shift the shift lever to P (automatic transmission or continuously variable transmission) or R (manual transmission).
● Stop the engine.
● Turn on the emergency flashers.
Other materials:
Overhaul
1. Remove generator pulley
Sst 09820–63010 (09820–06010, 09820–06020)
Hint:
Hold sst 1 – a with a torque wrench, and tighten sst 1
– b clockwise to the specified torque.
Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf)
Notice:
check that sst is secured to the rotor shaft.
...
Terminals of ecu
1. Inspect tvip ecu
Inspect the ecu–b, dome and ecu–ig fuses.
disconnect the tvip ecu connector, and the continuity and voltage of
check each terminal of the disconnected
connector.
Standard:
If the result is not as specified, the vehicle’s side may malfunction.
Reco ...
Evap monitor (vacuum pressure monitor)
Notice:
a cold soak must be performed prior to conducting the drive pattern to complete
the internal pressure
readiness monitor.
Cold soak preconditions
The monitor will not run unless:
mil is off.
Fuel level is approximately 1/2 to 3/4.
Altitude is 7800 feet (2400 m) or less.
...


