Toyota Corolla (E170): Before driving

Floor mat

Use only floor mats designed specifically for vehicles of the same model and model year as your vehicle. Fix them securely in place onto the carpet.

1 Insert the retaining hooks (clips) into the floor mat eyelets.

2 Turn the upper knob of each retaining hook (clip) to secure the floor mats

2 Turn the upper knob of each retaining hook (clip) to secure the floor mats in place.

*: Always align the marks.

The shape of the retaining hooks (clips) may differ from that shown in the illustration.

The shape of the retaining hooks (clips) may differ from that shown in the illustration.

CAUTION

Observe the following precautions.

Failure to do so may cause the driver’s floor mat to slip, possibly interfering with the pedals while driving. An unexpectedly high speed may result or it may become difficult to stop the vehicle, leading to an accident, or leading to death or a serious injury.

■When installing the driver’s floor mat

●Do not use floor mats designed for other models or different model year vehicles, even if they are Toyota Genuine floor mats.

●Only use floor mats designed for the driver’s seat.

●Always install the floor mat securely using the retaining hooks (clips) provided.

●Do not use two or more floor mats on top of each other.

●Do not place the floor mat bottom-side up or upside-down.

■Before driving

●Check that the floor mat is securely fixed in the correct place with all the provided retaining hooks (clips). Be especially careful to perform this check after cleaning the floor.

●With the engine stopped and the shift lever in P (automatic transmission or continuously variable transmission) or N (manual transmission), fully depress each pedal to the floor to make sure it does not interfere with the floor mat.

For safety drive

    Share this page:

    Other materials:

    Inspection
    1. Thermostat Hint: the thermostat is numbered with the valve opening temperature. Immerse the thermostat in water and gradually heat the water.  check the valve opening temperature. Valve opening temperature: 80 to 84 c (176 to 183 f) Hint: if the valve opening temperatur ...

    Dtc check/clear
    1. Dtc check (normal mode) Notice: hand–held tester only: when the diagnostic system is switched from the normal mode to the check mode, all the dtcs and freeze frame data recorded in the normal mode will be erased. So before switching modes, always check the dtcs and freeze frame data, and ...

    Hood
    Release the lock from the inside of the vehicle to open the hood. 1 Pull the hood lock release lever. The hood will pop up slightly. 2 Pull up the auxiliary catch lever and lift the hood. 3 Hold the hood open by inserting the support rod into the slot. CAUTION ■Pre-driving check C ...