Toyota Corolla (E120) 2002–2008 Repair Manual / Lighting / Back up lamp assy lh
Toyota Corolla (E120): Back up lamp assy lh
Replacement
1. Remove back up lamp assy lh
- Remove the service hole cover.
- remove the 2 nuts and disconnect the connector.
- Using a mouldingremover, remove the 2 clips and back up light assy lh.
2. Install back up lamp assy lh
- Set the 2 clips on the back up light assy lh as shown in the illustration.
- connect the connector.
- install the back up light lh with 2 nuts.
Other materials:
Toyota vehicle intrusion protection system
On–vehicle inspection
1. Outline of toyota vehicle intrusion protection (tvip) system
Hint:
the theft deterrent system has 2 modes; one is the active mode that is an
initially set mode and another is
the passive mode that can be switched on/off by the specified method (see step
4).
&nb ...
Torque converter clutch and drive plate (atm)
Inspection
1. Inspect torque converter clutch assy
Inspect the one–way clutch.
Set sst into the inner race of the one–way clutch.
Sst 09350–32014 (09351–32010)
set sst so that it fits in the notch of the converter
hub and outer race of the one–way clutch.
...
Inspection procedure
1 Check wire harness(dlc3 – airbag sensor assy center)
Turn the ignition switch to the lock position.
disconnect the aribag sensor assy center connector.
measure the resistance according to the value(s) in the
table below.
Standard:
2 Check wire harness(cg of dl ...