Toyota Corolla (E120) 2002–2008 Repair Manual / Automatic transmission / trans

Toyota Corolla (E120): Automatic transmission / trans

Share this page:

Other materials:

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

Adjustment
1. Headlight aim only  place the vehicle in the following conditions. The area around the headlight is not deformed. The vehicle is parked on a level surface. Tire inflation pressure is in the specified value . A driver is in the driver’s seat and the vehicle is in a state rea ...

Replacement
1. Drain engine oil  remove the oil pan drain plug and drain the engine oil. 2. Removal & installation chain sub–assy 3. Remove chain vibration damper no.1  remove 2 bolts and chain vibration damper no. 1. 4. Remove oil pump assy Remove the 5 bolts.  rem ...