Toyota Corolla (E170): Auto connection

To turn auto connection mode on, set “Bluetooth* Power” to on.

When you register a phone, auto connection will be activated. Always set it to this mode and leave the Bluetooth® phone in a place where a connection can be established.

When the engine switch is turned to ACCESSORY or ON <IGNITION ON> mode, the system will search for a nearby cellular phone you have registered.

Next, the system automatically connects with the most recent of the phones connected to in the past. Then, the connection result is displayed.

    Share this page:

    Other materials:

    Rear suspension
    Preparation Sst Recomended tools Equipment Tire & wheel Preparation Equipment ...

    Inspection procedure
    1 Check wire harness(dlc3 – airbag sensor assy center) Turn the ignition switch to the lock position.  disconnect the aribag sensor assy center connector.  measure the resistance according to the value(s) in the table below. Standard: 2 Check wire harness(cg of dl ...

    Front no.1 Speaker assy
    Replacement Hhint: components: 1. Remove front armrest assy lh 2. Remove power window regulator master switch assy (w/ power window) 3. Remove front armrest base panel upper lh (w/o power window) 4. Remove front door window regulator handle assy (w/o power window) 5. Remove front door lowe ...