Toyota Corolla (E120): Air bag sensor front lh

Components

Replacement

Hint

: components:

1. Precaution

2. Disconnect battery negative terminal

3. Remove air bag sensor front lh

  1. Disconnect the connector from the airbag sensor front lh.
  2.  remove the 2 bolts and airbag sensor front lh.

4. Inspect air bag sensor front lh

5. Install air bag sensor front lh

  1.  check that the ignition switch is turned to off.
  2.  check that the battery negative terminal is disconnected.

    Notice

    : do not start the operation for 90 seconds after removing the terminal.

  3.  install the airbag sensor front lh with the 2 bolts.

    Torque: 8.0 Nvm (82 kgfvcm, 71 invlbf)

  4.  connect the connector to the airbag sensor front lh.
  5.  check that no play is identified.

6. Inspect srs warning light

    Share this page:

    Other materials:

    Lubrication system
    *: The engine oil capacity is a reference quantity to be used when changing the engine oil. Warm up and turn off the engine, wait more than 5 minutes, and check the oil level on the dipstick. ■ Engine oil selection “Toyota Genuine Motor Oil” is used in your Toyota vehicle. Use Toyo ...

    Pre–check
    1. Diagnosis system Release the parking brake lever.  check the warning lights. When the ignition switch is turned on, check that the abs warning light and brake warning light goes on for 3 sec. Hint: when the parking brake is applied or the level of the brake fluid is low, the ...

    Radio receiver assy
    Replacement Рint: components: 1. Remove floor shift shift lever knob sub–assy (m/t transaxle) 2. Remove console panel upper 3. Remove heater control knob 4. Remove instrument cluster finish panel 5. Remove instrument cluster finish panel sub–assy center Remove the 4 screws. & ...