Toyota Corolla (E170): Adjustment procedure

1 Hold the steering wheel and push the lever down.

2 Adjust to the ideal position by moving the steering wheel horizontally and

2 Adjust to the ideal position by moving the steering wheel horizontally and vertically.

After adjustment, pull the lever up to secure the steering wheel.

Horn

    Share this page:

    Other materials:

    Chassis
    On–vehicle inspection 1. Inspect steering linkage  check the steering wheel freeplay .  check the steering linkage for looseness or damage.  Check that the tie rod ends do not have excessive play.  Check that the dust seals and boots are not damaged.  Chec ...

    Back up lamp assy lh
    Replacement 1. Remove back up lamp assy lh Remove the service hole cover.  remove the 2 nuts and disconnect the connector. Using a mouldingremover, remove the 2 clips and back up light assy lh. 2. Install back up lamp assy lh Set the 2 clips on the back up ligh ...

    On–vehicle inspection
    1. Inspect turn signal flasher relay circuit Disconnect the connector from the turn signal flasher relay and inspect the connector on wire harness side as shown in the chart. Standard: Connect the connector to the turn signal flasher and inspect the wire harness side connector ...