Toyota Tacoma manuals

Toyota Corolla Repair Manual: Adjustment

1. Headlight aim only

  1.  place the vehicle in the following conditions.
  1.  check the headlight aiming.
  1.  Prepare a thick white paper.
  2.  Stand the paper perpendicular to the ground at the position 9.84 Ft away from the headlights.
  3.  Ensure that the center line of the vehicle and the paper face forms a 90degree angle as shown in the illustration.
  4.  Draw a horizontal line (h line) on the paper, showing where the headlights should strike.
  5.  Draw a vertical line (v line) to where the center line of the vehicle is to be.
  6.  Draw 2 vertical lines to where the both headlights should strike (v rh and v lh lines).
  7. Draw a horizontal line (by connecting the both low beam center marks) to where the headlights should strike (h rh and h lh lines).
  8. Take appropriate measures to prevent any influence of other lights.
  9.  Set the headlights leveling position to 0 position and adjust the angle of the headlight axis.

Hint

: the h rh and h lh line is 0.4 Below the horizontal line (h line) of the light axis.

  1.  Start the engine.
  2.  Turn the headlights on.
  3.  Check that the headlights properly strike the position shown in the illustration.
  4.  If not, adjust the lights in the vertical direction.

Hint:

Hint

:

  1. as shown in the illustration, adjust each aim of the rh and lh lights.

  1. When adjusting the headlight aim in the veatical direction: using adjusting bolt, adjust the headlight aim to be within the specified range.

Hint

: the optical aim moves upward when turning a screwdriver clockwise, while it moves downward when turning a screwdriver counterclockwise.

Replacement
Hint: components: 1. Remove radiator grille subassy 2. Remove front bumper cover 3. Remove lh headlamp assy Remove the 3 bolts.  pull out the headlight assy lh forward, then discon ...

Fog lamp assy lh
...

Other materials:

Onvehicle inspection
1. Horn button assy (vehicles not involved in collision) Check the diagnostic system . visually check the following item with the horn button assy (with airbag) installed in the vehicle. Check cuts, minute cracks or marked discoloration on the horn button assy top surface and in the ...

Circuit description
The side squib (lh) circuit consists of the airbag sensor assy center and front seat airbag assy (lh). It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0115/47 is recorded when a short is detected in the side squib (lh) circuit. Wiring diagram ...

Customization
Customizable features Your vehicle includes a variety of electronic features that can be personalized to suit your preferences. Programming these preferences requires specialized equipment and may be performed by your Toyota dealer. Customizing vehicle features ■ Changing by using the n ...

2011-2022 Copyright www.tcorolla.net