Toyota Corolla (E120): Adjustment
1. Inspect park/neutral position switch assy
- apply the parking brake and turn the ignition switch on.
- depress the brake pedal and check that the engine starts only when the shift lever is set in n or p position and it does not start in the other position.
- check that the back–up light comes on and the reverse warning
buzzer sounds only when the shift
lever is set in r position and these do not function in the other positions.
If a failure is found, check the park/ neutral position switch for continuity.
2. Adjust park/neutral position switch assy
- Loosen the 2 bolts of park/ neutral position switch and set the shift lever to the n position.
- align the groove and neutral basic line.
- hold the switch in position and tighten the 2 bolts.
Torque: 5.5 Nvm (56 Kgf·cm, 49 in.Vlbf)
- after adjustment, perform the inspection described in step 1.
Other materials:
Bluetooth® audio/phone
The following can be performed using Bluetooth® wireless communication:
■ Bluetooth® audio
The Bluetooth® audio system enables you to enjoy music played on a portable
player from the vehicle speakers via wireless communication.
This audio system supports Bluetooth®, a wireless data sy ...
Inspection procedure
1 Check p/t squib(lh) circuit(airbag sensor assy center – front seat
outer belt assy lh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the seat belt pretensio ...
Circuit description
Refer to dtc p0115
Dtc no.
Dtc detection condition
Trouble area
P0125
If the engine coolant temperature (ect) was less than –6.6 °C
(20 °F) when starting the engine, and 20 minutes after the engine
start, the ect sensor still indicates below 20 °C (68 ...