Toyota Corolla (E120): Actuator motor circuit

Dtc 11 actuator motor circuit

Dtc 15 actuator motor circuit

Share this page:

Other materials:

On–vehicle inspection
1. Install lspv gauge (sst) and bleed air  remove the bleeder plugs from the front and rear brake cylinder.  install the lspv gauge (sst), and bleed the air. Sst 09709–29018 2. Raise master cylinder pressure and check rear wheel cylinder pressure Hint: when inspectin ...

Replacement
1. Remove front door scuff plate rh Using a screwdriver, remove the front door scuff plate rh. Hint: tape the screwdriver tip before use. Remove front door scuff plate lh Remove rear door scuff plate rh Using a screwdriver, remove the rear door scuff plate rh. Hint: tap ...

Inspection procedure
1 Check p/t squib(rh) circuit(airbag sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensio ...