Toyota Corolla (E120): Abs warning light circuit (does not light up)

Inspection procedure

Circuit description

Other materials:

Oxygen sensor monitor (front and rear o2s system)
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 2 minutes or more.  Drive the vehicle at 25 mph ...

Heater & air conditioner
Preparation Sst Recomended tools Equipment Lubricant ...

Manual transaxle oil
On–vehicle inspection 1. Inspect transaxle oil Stop the vehicle on the level place.  remove the transmission filler plug and gasket.  check that the oil surface is within 5 mm (0.20 In.) From the lowest position of the inner surface of the transmission filler plug openin ...