Toyota Corolla (E140) 2007–2013 Body Repair Manual / Introduction / About this vehicle
Toyota Corolla (E140): About this vehicle
1. Structural outline
2. Notice about vehicle condition when jacking up vehicle
(a) notice for using jack and safety stand
(B) notice for using swing arm type lift
(C) notice for using plate type lift
3. Damage diagnosis
4. Components
(a) front bumper
(B) side mudguard
(C) rear bumper
(D) door
(E) cowl top ventilator louver
(F) instrument panel
(G) interior trim
(H) seat
5. Wheel alignment standard
(a) front wheel alignment
(1) Vehicle height (unloaded vehicle)
Notice
:
- before inspecting the wheel alignment, adjust the vehicle height to the specified value.
- Be sure to perform measurement on a level surface.
- If it is necessary to go under the vehicle for measurement, confirm that the parking brake is applied and the vehicle is secured with chocks.
Measuring points:
- no. 1 Lower suspension arm bushing set bolt ground clearance
- rear axle beam set bolt ground clearance
- front wheel center ground clearance
- rear wheel center ground clearance
*For vehicle height for mexico, add 15 mm (0.591 In.)
(2) Wheel angle (unloaded vehicle)
*For vehicle height for mexico, add 15 mm (0.591 In.) If the angles are not as specified, check and adjust the right and left rack end lengths.
(3) Camber (unloaded vehicle)
* For vehicle height for mexico, add 15 mm (0.591 In.)
(4) Caster (unloaded vehicle)
* For vehicle height for mexico, add 15 mm (0.591 In.)
(5) Steering axis inclination (unloaded vehicle) except tmc made:
* For vehicle height for mexico, add 15 mm (0.591 In.)
(6) Toe-in
Hint:
- measure “b - a” only when “c + d” cannot be measured.
- If toe-in is not within the specified range, adjust it at the rack ends.
(B) rear wheel alignment
(6) Toe-in (unloaded vehicle)
- measure “b - a” only when “c + d” cannot be measured.
* For vehicle height for mexico, add 15 mm (0.591 In.) If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.
(2) Camber (unloaded vehicle)
Hint: camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.
Other materials:
Replacement
Hint:
installation is in the reverse order of the removal. But the
installation is indicated only when it has a
point.
In the lh side, work in the same procedure as in the rh side.
1. Disconnect battery negative terminal
2. Remove front seat assembly rh
3. Remove front seat inner be ...
Components
...
How to proceed with troubleshooting
1 Vehicle brought to workshop
2 Customer problem analysis
3 Problem symptom confirmation
4 Circuit inspection
5 Repair or replace
6 Confirmation test
7 End
Customer problem analysis check
...