Toyota Corolla (E170): “SET UP” menu

Share this page:

Other materials:

Inspection procedure
1 Check p/t squib(rh) circuit(airbaga sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensi ...

Precaution
1. Handling precautions on srs airbag system The vehicle is equipped with srs (supplemental restraint system) such as the driver airbag and front passenger airbag. Failure to carry out service operation in correct sequence could cause the srs to unexpectedly deploy during servicing, po ...

Speed sensor front lh
Replacement Hint: replace the rh side by the same procedure as the lh side. 1. Remove front wheel 2. Remove front fender liner lh 3. Remove speed sensor front lh Disconnect the speed sensor wire harness clamp from the body.  disconnect the speed sensor connector. Remo ...