Toyota Corolla (E210): Seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle.

WARNING

Observe the following precautions to reduce the risk of injury in the event of sudden braking, sudden swerving or an accident.

Failure to do so may cause death or serious injury.

■Wearing a seat belt

  • Ensure that all passengers wear a seat belt.
  • Always wear a seat belt properly.
  • Each seat belt should be used by one person only. Do not use a seat belt for more than one person at once, including children.
  • Toyota recommends that children be seated in the rear seat and always use a seat belt and/or an appropriate child restraint system.
  • To achieve a proper seating position, do not recline the seat more than necessary. The seat belt is most effective when the occupants are sitting up straight and well back in the seats.
  • Do not wear the shoulder belt under your arm.
  • Always wear your seat belt low and snug across your hips.

■Pregnant women

Obtain medical advice and wear

Obtain medical advice and wear the seat belt in the proper way.

Women who are pregnant should position the lap belt as low as possible over the hips in the same manner as other occupants, extending the shoulder belt completely over the shoulder and avoiding belt contact with the rounding of the abdominal area.

If the seat belt is not worn properly, not only the pregnant woman, but also the fetus could suffer death or serious injury as a result of sudden braking or a collision.

■People suffering illness

Obtain medical advice and wear the seat belt in the proper way.

■Seat belt damage and wear

  • Do not damage the seat belts by allowing the belt, plate, or buckle to be jammed in the door.
  • Inspect the seat belt system periodically. Check for cuts, fraying, and loose parts. Do not use a damaged seat belt until it is replaced. Damaged seat belts cannot protect an occupant from death or serious injury.
  • Ensure that the belt and plate are locked and the belt is not twisted.

    If the seat belt does not function correctly, immediately contact your Toyota dealer.

  • Replace the seat assembly, including the belts, if your vehicle has been involved in a serious accident, even if there is no obvious damage.
  • Do not attempt to install, remove, modify, disassemble or dispose of the seat belts. Have any necessary repairs carried out by your Toyota dealer. Inappropriate handling may lead to incorrect operation.
    Share this page:

    Other materials:

    Circuit inspection
    1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the horn button assy.  connect the ...

    Gauges and meters (multi-information display)
    The displayed content may differ depending on the type of meter. 1 Tachometer Displays the engine speed in revolutions per minute. 2 Speedometer 3 Fuel gauge 4 Multi-information display The multi-information display presents the driver with a variety of drivingrelated data including the cu ...

    Inspection procedure
    1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...