Toyota Corolla (E170): Shifting the shift lever

While the engine switch is in the

“ON” position, depress the brake pedal and move the shift lever. While the engine switch is in the “ON” position, depress the brake pedal and move the shift lever.

    Share this page:

    Other materials:

    Overhaul
    Hint: overhaul the rh side by the same procedures with lh side. 1. Remove rear wheel 2. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove rear brake drum sub–assy Release the parking brake lever, and remove t ...

    On–vehicle inspection
    1. Check cooling fan operation with low temperature (below 83 c (181 f)) Turn the ignition switch on.  check that the cooling fan stops. Hint: if not, check the cooling fan relay and water temperature sensor, and check for separated connector or severed wire between the cooling fan ...

    How to proceed with troubleshooting
    1 Vehicle brought to workshop 2 Customer problem analysis 3 Problem symptom confirmation 4 Circuit inspection 5 Repair or replace 6 Confirmation test 7 End Customer problem analysis check ...