Toyota Corolla (E170): Opening the trunk from inside the vehicle

Pull up the lever to release the trunk lid.

Opening the trunk from outside the vehicle

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

    Inspection procedure
    1 Check p/t squib(rh) circuit(airbaga sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensi ...

    Pre–check
    1. Pre–check Check that the cruise control actuator assy, acceleration wire, accelerator auto drive cable assy, and link assy are installed correctly and that the wire and link are securely connected. check that the operating movement of the acceleration pedal, cruise control actu ...