Toyota Corolla (E120): On–vehicle inspection

1. Install lspv gauge (sst) and bleed air

  1.  remove the bleeder plugs from the front and rear brake cylinder.
  2.  install the lspv gauge (sst), and bleed the air.

    Sst 09709–29018

2. Raise master cylinder pressure and check rear wheel cylinder pressure

Hint:

Hint

: when inspecting the fluid pressure, inspect the left front and right rear together, and the right front and left rear together. If the rear wheel cylinder pressure is imprper, replace the proportioning valve assy.

3. Remove lspv gauge (sst)

  1.  remove the lspv gauge (sst).

    Sst 09709–29018

  2.  install the bleeder plugs.

    Torque: 8.3 Nvm (85 Kgf·cm, 74 in.Vlbf)

4. Bleed master cylinder

 sst 09023–00100

5. Bleed brake line

6. Check for leaks

    Share this page:

    Other materials:

    Chassis
    On–vehicle inspection 1. Inspect steering linkage  check the steering wheel freeplay .  check the steering linkage for looseness or damage.  Check that the tie rod ends do not have excessive play.  Check that the dust seals and boots are not damaged.  Chec ...

    Windshield wipers and washer
    Operating the lever can use the windshield wipers or the washer. NOTICE ■When the windshield is dry Do not use the wipers, as they may damage the windshield. Operating the wiper lever Operating the lever operates the wipers or washer as follows. (U.S.A.) or (Canada) Intermittent windshield ...

    Replacing light bulbs
    ■ Headlight high beams 1 Turn the bulb base counterclockwise. 2 Pull the bulb out while pressing the lock release of the connector. 3 Replace the light bulb, and install the bulb base. Align the 3 tabs on the light bulb with the mounting and insert. 4 Turn and secure the bulb base. ...