Toyota Corolla (E170): Locking the doors from the outside without a key

1 Move the inside lock button to the lock position.

2 Close the door.

► Vehicles without a smart key system The door cannot be locked if either of the front doors is open and the key is in the engine switch.

► Vehicles with a smart key system The door cannot be locked if the engine switch is in ACCESSORY or IGNITION ON mode, or the electronic key is left inside the vehicle.

However, the key may not be detected correctly and the door may be locked.

    Share this page:

    Other materials:

    Adjusting the set speed
    To change the set speed, operate the lever until the desired set speed is obtained. 1 Increases the speed 2 Decreases the speed Fine adjustment: Momentarily move the lever in the desired direction. Large adjustment: Hold the lever in the desired direction. The set speed will be increased or dec ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove horn button assy Place the front wheels facing straight ahead.  using a torx socket wrench (t30), loosen the 2 torx screws until the groove along the screw circumference catches on the screw ca ...