Toyota Corolla (E120): Inspection

1. Inspect clutch start switch assy

  1. Check the continuity between the terminals when the switch is on and off.

Replacement

    Share this page:

    Other materials:

    Replacement
    Hint: installation is according to the reverse order of the removal. 1. Remove rear door weatherstrip rh 2. Remove rear door weatherstrip lh 3. Remove rear seat cushion assy (, 72–8) 4. Remove rear seat back assy (fixed type rear seat) 5. Remove separate type rear seat back assy (separate ...

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Inspection procedure
    1 Inspect terminal voltage(od – body ground) Disconnect the cruise control ecu connector.  turn the ignition switch to the on position.  measure the voltage between terminal od of cruise control ecu and body ground. Standard: 2 Inspect terminal voltage(od1 – bod ...