Toyota Corolla (E120): Components
Other materials:
Inspection procedure
1 Check relay (marking: starter cut)
Inspect the relay continuity, as shown in the illustration
and table.
Standard:
2 Check tvip ecu
Disconnect the tvip ecu connector.
turn the ignition switch position to the start.
measure the voltage between the termina ...
Inspection procedure
1 Check d squib circuit(airbag sensor assy center – horn button
assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the horn button assy.
release the airbag activ ...
Circuit description
When the ignition switch is turned on, battery positive voltage is applied to
the coilwhich closes the contacts
of the efi main relay (marked: efi) and supplies power to terminal +b of the ecm.
This signal causes current to flow to the coil, closing the contacts of the efi
relay and supplyin ...